Cascade Refrigeration System

Cascade Refrigeration System

In the industrial refrigeration cycle system, low temperature can be obtained by adopting two-stage or multi-stage compression refrigeration cycle, which solves the problem of excessive pressure ratio. If the two-stage or multi-stage vapor compression refrigeration cycle cannot meet this requirement, we need to use the cascade refrigeration system. There are three main reasons why cascade refrigeration system must be adopted.

1. The result characteristics of piston compressor valves are limited: low evaporation pressure affects the automatic switching characteristics of reciprocating piston compressor valves, which deviates from the design range. When the suction pressure is 10~16kPa, the suction valve of the compressor does not open, and the compressor cannot suck. On the other hand, the compressor and the low-pressure part of the system operate under high vacuum, and the possibility of intrusion of non-condensable gas becomes high.

2. Limitation of refrigeration cycle pressure ratio: Once the necessary evaporation pressure is too low, even if the two-stage compression refrigeration cycle is used, the pressure ratio of each stage still exceeds the specified value, which greatly reduces the efficiency of the refrigeration cycle. In addition, with multi-stage compression, the cycle pressure is guaranteed, but the refrigeration system is complex and the technical and economic indicators are not high.

3. Restricted by the freezing point of the refrigerant: when the evaporation temperature required by the refrigeration cycle system of the chiller is lower than the freezing point of the refrigerant, the refrigerant freezes and cannot flow, and the system cannot circulate. For example, because the freezing point of R17 is -77.7°C, it is obviously not suitable for the refrigeration cycle system whose evaporation temperature is below -77.7°C.

Based on the above three points, it is unfavorable or impossible to use a single refrigerant multi-stage compression refrigeration cycle chiller to obtain a lower temperature. Although the evaporation temperature of the multi-stage compression refrigeration cycle is lower than that of the single-stage compression refrigeration cycle, it is limited by the physical properties of the refrigerant itself and the working characteristics of the compressor. When the evaporation temperature is lower, the multi-stage compression refrigeration cycle is used. Often can not meet the requirements, at this time, need to use cascade refrigeration system.

Soluciones personalizadas para su empresa

Refrigeradores de baja temperatura (por agua y por aire)

Rango de control de temperatura: -150°C a -5°C

Estamos especializados en la producción de refrigeradores de baja temperatura con un rango de control de temperatura de hasta -150°C, que pueden satisfacer las necesidades de refrigeración de diferentes industrias.

Enfriadoras de recirculación (Refrigeración por agua y por aire)

Rango de control de temperatura: -120°C a +30°C

Nuestro enfriador de recirculación adopta tecnología de refrigeración de baja temperatura, la temperatura es tan baja como -120℃, y varios accesorios son personalizables.

Refrigeradores de temperatura ambiente / Refrigeradores pequeños

Rango de control de temperatura: +5°C a +50°C

El enfriador puede utilizarse ampliamente en diversas industrias y laboratorios, y admite diseños personalizados.

Equipos frigoríficos de refrigeración directa

Rango de control de temperatura: -120°C a -10°C

Es adecuado para lugares con poca superficie de intercambio de calor y gran intercambio de calor.

Enfriadoras de temperatura ultrabaja de refrigeración directa

Rango de control de temperatura: -150°C a -110°C

Soluciones personalizadas para su empresa.

Refrigeradores de tornillo

Refrigeradores de tornillo de baja temperatura y refrigeradores de tornillo a temperatura ambiente

Soluciones personalizadas para su empresa.